曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
.
RADIO ADV/DATA selector/PUSH SELECT knob – Used for tuning, mode and operational selections.
.
RADIO button – Shows the radio control submenu when pressed. Pressing the button again returns the display to the main radio tuning block.
.
FREQ button – Swaps the active/recall/preset frequency for the highlighted radio.
.
1/2 button – Enables cross-side tuning. When pressed, the on-side MFD shows tuning data from the opposite MFD.
Cursor Control Panel Figure 06.10.8
MFD Radio Tuning Window
The MFD radio tuning window is divided into systems which have selectable frequencies, functions, or operating modes. The cyan tuning box is defaulted to surround the RECALL frequency of VHF radio no.1 when power is first applied.
When the RADIO ADV selector is rotated, the tuning box moves over selectable systems and functions, including tuning, mode and operational selections. Changes can only be made to the selected system when the PUSH SELECT button is pushed.
When a VHF radio frequency is selected and the tune box is made active, the box is split in two. The left half, the most significant digit (coarse), is controlled by the RADIO ADV selector, while the right half, the least significant digits (fine), is controlled by the DATA selector.
When the tune box is enabled for the current active frequency and a frequency change is made, the previous frequency moves to the recall frequency line. When the tune box is made active for the recall frequency and a frequency change is made, the previously indicated frequency is lost while the new frequency is shown. Unlike tuning from the CDU method, the words RECALL and PRESET are not shown on the tuning window.
COMMUNICATIONS Description Vol. 2 06.10.15
Oct 05/06
No frequency selection can be made to VHF COM no.3 when operating in a VHF datalink mode. This is annunciated by the word DATA in green on the tuning window.
When an HF radio frequency is selected and made active, the tune box surrounds the left digit only. The DATA selector is used to change the digit while the RADIO ADV selector is rotated to move to the next digit.
MFD Radio Tuning Block Figure 06.10.9
MFD Radio Tuning Control Page Navigation
Pressing the RADIO button on the CCP causes the radio’s submenu to be shown. The RADIO ADV/DATA selector and PUSH SELECT button are used to move and make selections.
The submenu functions are similar to what is displayed on the CDU CONTROL page, with the exception that no preset frequencies or channels are available.
The VHF radio control submenu provides control and display of the following:
.
Squelch mode selection;
.
Test function;
.
Active/Recall frequency transfer; and
.
Voice/Data selection (VHF 3 only).
COMMUNICATIONS Description Vol. 2 06.10.16
中国公务机网 www.gongwuji.com
公务机翻译 www.aviation.cn
本文链接地址：庞巴迪挑战者605公务机机组操作手册 CL605-通讯 COMMUNICATIONS(7)
| 
