曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
-The smaller (inner knob) tunes the digits to the right of the decimal point.
5.
To activate the new frequency/channel:
-Push the transfer button in the center of the tune knob.
6.
To change modes, adjust squelch, and other non-tuning functions of a radio: -Turn the MENU knob to move the selection box to the appropriate radio (COM1, NAV2, ATC/TCAS, etc.) -Push the RADIO button on the DCP to select the submenu. -Turn the MENU knob to move the selection box on the submenu. -Turn the DATA knob to change the mode or select an option)i.e, tune mode, squelch level, traffic mode, etc.) -Push the PUSH SELECT button to step through available options. (the PUSH SELECT button acts the same
as the DATA knob in selecting options)
-To exit the sub menu, push the RADIO button. The display returns to the radio menu.
NOTE: The menu is automatically removed 20 seconds after the last activity of the MENU, DATA, or PUSH SELECT knob, or when another menu or list button is pushed.
Volume 2 Flight Crew Operating Manual Sep 13/2004 CSP 100-6 REV 1
06-01-06 VHF COMMUNICATION (Cont)
DISPLAY CONTROL PANEL COM RADIO OPERATION
The radio menu provides basic COM radio tuning control. The COM submenu provides control display for other COM radio operation. Each COM radio installed on the aircraft has its own submenu. The active frequency, recall frequency, and squelch status displays are identical to the display on the radio menu.
The current control location is indicated by a cyan control box. The default location is the last tuned communication radio (VHF or HF). After 20 seconds of inactivity, the cyan control box returns to the default location.
Selecting the 1/2 button results in the cross side radios being displayed and the radio legends being displayed in yellow.
.
-Push the RADIO button on the DCP to show the radio menu on the MFD if another menu/list is active -Turn the MENU knob on the DCP to move the selection box to the desired radio (COM 1, COM 2, COM 3 if
installed) display on the radio menu. -Push the RADIO button on the DCP to show the appropriate submenu on the MFD -The following operations are performed on the submenu
-Change the SQUELCH mode
-Turn the MENU knob to move the selection box to the SQUELCH control.
-Turn the DATA knob or push the PUSH SELECT button to select the squelch ON or OFF
-Change the frequency spacing for radio tuning
-Turn to MENU knob to move the selection box to the FREQ SEL control.
-Turn the DATA knob or push the PUSH SELECT button to select 8.33 or 25 kHz spacing for tuning
-Select the COM TEST mode
-Turn the MENU knob to move the selection box to the TEST control.
-Turn the DATA knob or push the PUSH SELECT button to select the TEST mode
-Change the COM 3 mode (only if Voice/Data option is enabled)
中国公务机网 www.gongwuji.com
公务机翻译 www.aviation.cn
本文链接地址：庞巴迪挑战者300公务机机组操作手册 Bombardier_Challenger-通讯(6)
| 
