曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
The displayed navigation source will determine which navigation submode will be in operation.
NAV Source Selection
The navigation source may be selected using the PRESET NAV box or the PFD menu.
.
PRESET NAV box: Select desired preset NAV source by rotating the data knob on the DCP, then push the NAV SRC swap button.
.
PFD menu: Press MENU button on the DCP, and use the menu ADV/DATA knob to select the desired NAV source.
LOC or VOR navigation source is determined by the ground station frequency set in the radio tuning window.
All NAV mode annunciations appear in the lateral field of the FMA: armed modes in white, and active/captured modes in green. Captures that are inhibited due to invalid data are annunciated on the PFDs as a red horizontal line through the mode annunciation.
AUTOMATIC FLIGHT CONTROL SYSTEM Description Vol. 2 04.10.20
Oct 05/06
Display Control Panel
Figure 04.10.18
Navigation Source Selection Display
Figure 04.10.19
AUTOMATIC FLIGHT CONTROL SYSTEM Description Vol. 2 04.10.21
Oct 05/06
VOR Navigation Mode
In the VOR navigation mode, the flight director generates lateral steering commands to capture and track the selected VOR radial (inbound or outbound), using the course displayed on the active navigation source.
When the NAV button is pressed and the active navigation source is VOR1 or VOR2, the VOR navigation mode is armed. The armed lateral mode field on both PFDs shows a white VOR1 (or VOR2) annunciation. When the VOR mode is captured, the armed annunciations are removed, and a green VOR1 (or VOR2) annunciation is displayed in the active lateral mode field on the PFDs.
The CRS1 and CRS2 knobs, located on the FCP, provide the means to select the desired course on the left and right PFD HSI respectively. Pressing the PUSH DIRECT knob within the CRS knob synchronizes the corresponding course display, and provides a “direct-to” VOR course.
VOR navigation mode is designed to permit tracking over station, and allow for course changes while tracking. When over a VOR station, the system can accept and follow a course change of up to 90°. Dead reckoning operation (based on memorized heading) is provided during VOR station passage. A white DR annunciation appears next to the active VOR mode annunciation during dead reckoning operation.
When captured, VOR navigation mode is cleared automatically by selection of another lateral mode, by changing the active NAV source, or by loss of the VOR signal. VOR navigation mode can also be cleared by pressing the NAV button again.
AUTOMATIC FLIGHT CONTROL SYSTEM Description Vol. 2 04.10.22
Oct 05/06
VOR Navigation Mode Figure 04.10.20
Localizer Navigation Mode
In localizer navigation mode, the flight director provides lateral steering commands to capture and track the front course localizer from the active navigation source.
中国公务机网 www.gongwuji.com
公务机翻译 www.aviation.cn
本文链接地址：庞巴迪挑战者605公务机机组操作手册 CL605-AUTOMATIC_FLIGHT_CONTROL_SYSTEM(12)
| 
