返回首页

庞巴迪挑战者605公务机机组操作手册 CL605-AUTOMATIC_FLIGHT_CONTROL_SYSTEM(9)

时间:2011-10-27 00:46来源:蓝天飞行翻译 作者:公务机
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
  
In the above modes, the FD1 and FD2 annunciations are not displayed on the PFDs.

Independent "Split" FD Mode Figure 04.10.11


Flight Mode Annunciator (FMA)
Lateral and vertical FD modes are presented in the flight mode annunciator (FMA) displayed on each PFD. The FMA is located above the PFD ADI display.
The FMA is divided into two fields, separated by vertical cyan lines. The left field displays the lateral flight director modes. The right field displays the vertical FD modes. Each field has two lines, the top indicates the active or captured mode (green), the bottom line indicates the armed modes (white). Certain conditions will trigger the use of yellow, and will be explained under each mode.
FMA Active/Captured Mode Display
The active/captured lateral and vertical modes are displayed in steady green text. Lateral and vertical modes that are capturing are displayed in flashing green text for five seconds, then change to steady green text.
If the active lateral or vertical mode becomes invalid (sensor data), the flight control system removes the invalid steering commands from the affected flight director. A red horizontal line is superimposed over the affected active mode annunciation (e.g.
FMA Armed Mode Display
The armed lateral and vertical modes are normally displayed in steady white text in the lower portion of the lateral or vertical field. Up to two vertical modes may be armed simultaneously.

 

 AUTOMATIC FLIGHT CONTROL SYSTEM Description  Vol. 2  04.10.14 
Oct 05/06 


Flight Mode Annunciator (FMA) Figure 04.10.12

FD Activation
There are three methods to activate the flight director:
.
Selecting a lateral or vertical mode on the flight control panel;

.
Engaging autopilot; or

.
Pushing takeoff/go-around (TOGA) switches.

 

FD Deactivation
The flight director is deactivated with the FD button on the FCP.
When the autopilot is not engaged, pressing the FD button on the offside will deactivate the offside flight director only. Pressing the onside FD button disengages both flight directors. When the autopilot is engaged, pressing the FD button on the offside will deactivate the offside
flight director only. Pressing the onside FD button has no effect. The FD button is inhibited during an overspeed condition.

FD Synchronization
The FD SYNC switch synchronizes the FD command bar reference values to the values flown at the time of selection. The FD SYNC switch is located on the back outboard horn of the pilot’s and copilot’s control wheels.


 AUTOMATIC FLIGHT CONTROL SYSTEM Description  Vol. 2  04.10.15 
Oct 05/06 

The following flight director modes can be synchronized to the current aircraft conditions when the FD SYNC switch is depressed:
.
FLC (indicated airspeed/Mach);
 
中国公务机网 www.gongwuji.com
公务机翻译 www.aviation.cn
本文链接地址:庞巴迪挑战者605公务机机组操作手册 CL605-AUTOMATIC_FLIGHT_CONTROL_SYSTEM(9)
 

------分隔线----------------------------