|
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
2.
Turn the MENU knob on the DCP to position the selection box around the desired radio tune frequency/channel/ mode display.
When using the active tune method the frequency color changes from green to white. Active tuning is used for transponder beacon code selection. Usually radio control other than frequency/channel tuning is done on the radio’s sub menu. Radio control uses the selection box method as follows:
1.
Repeat steps 1 and 2 above to position the selection box within the display for the desired radio on the MFD radio menu.
2.
Push the RADIO push button and the sub menu for the selected radio will replace the top level menu. (The process of tuning on the MFD radio sub menu is identical to tuning on the MFD radio menu).
3.
Turn the MENU knob to position the selection box around the desired radios control.
4.
Turn/push the DATA knob on the DCP to select the desired state of the selected control
The selection box returns to its MFD main radio menu home position after 20 seconds of no activity on the sub menu or by
again pushing the RADIO (on the DCP) push button again. Pushing a menu push button will replace the sub menu with the
top level menu and operate as required for the push button. The selection box is immediately positioned around the tune
frequency/channel display on the sub menu and frequency/channel is tuned if the TUNE knob is turned, or the 2 knob is
pushed.
The beacon code entry uses active tuning control operation and any code may be entered between 0000 and 7777. The
IDENT switch is located on both control wheels and stays active for approximately 18 seconds when pushed.
The TRANSPONDER/TCAS mode selection and annunciation is on the TRANSPONDER/TCAS radio primary display
page on the MFD and on the TRANSPONDER/TCAS control radio submenu. Selections are as follows:
-When using the DATA button the possible mode selections in order of succession are STBY, TA/RA, TA ONLY, ALT ON, ALT OFF. The order reverses if the DATA knob is turned counterclockwise
-When STBY, ALT ON or ALT OFF are selected, a 2 second delay is imposed before transmitting that mode selec-tion to the TCAS. When STBY is selected, a 2 second delay is imposed before transmitting to ATC. The standby command delay prevents transient selection of standby during mode selection
-The transponder reports altitude in TA/RA, TA ONLY and ALT ON modes. -The TRANSPONDER/TCAS mode selection on the MFD display is replaced with XPDR FAIL if the transponder is failed and the mode is not in STBY -When ALT OFF is selected, a 2 second delay is imposed before transmitting the mode selection to
prevent transient selection during mode selection The altitude limits selection and annunciation is on the TRANSPONDER/TCAS radio primary display and TRANSPON-DER/TCAS radio sub menu. The selections are as follows:
-When using the DATA button the possible selections are ABV, NORM, BLW, and ABV/BLW. The order reverses if the DATA knob is turned counterclockwise -ABV selects the above altitude limit, BLW selects the below altitude limit. When both are selected, the unre-
中国公务机网 www.gongwuji.com
公务机翻译 www.aviation.cn
本文链接地址：庞巴迪挑战者300公务机机组操作手册 Bombardier Challenger-导航(11)
| 
