曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
To tune the TRANSPONDER/NAV radio execute the following steps:
1.
Push the RADIO button on the DCP to show the radio menu on the MFD if another menu/list is active.
2.
Turn the MENU knob on the DCP to move the selection box to the TRANSPONDER/TCAS display on the radio menu.
3.
Push the RADIO button on the DCP to show the TRANSPONDER/TCAS CONTROL menu on the MFD.
4.
The following operations are performed on the TRANSPONDER/TCAS CONTROL menu:
-Select TCAS traffic altitude mode.
-Turn the MENU knob to move the selection box to the TRAFFIC control
-Turn the DATA knob or push the PUSH SELECT button to select traffic altitude mode REL (relative) or ABS
(absolute)
-Select the active transponder.
-Turn the MENU knob to move the selection box to the transponder control
-Turn the DATA knob or push the PUSH SELECT button to select ATC 1 or ATC 2 as the active transponder
-Set the Flight ID
-Turn the MENU knob to move the selection box to the Flight ID control
-Turn the TUNE knobs to set the desired Flight ID characters
- Select the ATC/TCAS TEST mode.
-Turn the MENU knob to move the selection box to the TEST control
-Turn the DATA knob or push the PUSH SELECT button to select the TEST mode
ADF RADIO OPERATION
The radio menu provides basic ADF radio tuning. The ADF CONTROL menu provides control display for other ADF radio operations. Each ADF radio installed on the aircraft has its own ADF CONTROL menu. If only one ADF radio is installed, it shows on both the on-side and cross-side menus, and will be labeled ADF CONTROL with no numerical designator. The active frequency, recall frequency, and antenna mode that show on he left of the ADF CONTROL menu are identical to the ADF display on the radio menu.
To set the ADF modes execute the following steps:
1.
Push the RADIO button on the DCP to show the radio menu on the MFD if another menu/list is active.
2.
Turn the menu knob on the DCP to move the selection box to the ADF radio (ADF 1 or ADF 2) display on the radio menu.
3.
Push the RADIO button on the DCP to show the ADF CONTROL menu on the MFD.
4.
The following operations are performed on the ADF CONTOL menu:
-Select the ADF/ANT mode.
-Turn the MENU knob to move the selection box to the MODE control
-Turn the DATA knob or push the PUSH SELECT button to select ADF or ANT mode
-Select BFO mode.
-Turn the MENU knob to move the selection box to the BFO control
-Turn the DATA knob or push the PUSH SELECT button to select ON or OFF for the BFO mode
- Select ADF TEST mode.
-Turn the MENU knob to move the selection box to the TEST control
-Turn the DATA knob or push the PUSH SELECT button to select the TEST mode
Volume 2 Flight Crew Operating Manual May 06/2005 CSP 100-6 REV 2
中国公务机网 www.gongwuji.com
公务机翻译 www.aviation.cn
本文链接地址：庞巴迪挑战者300公务机机组操作手册 Bombardier Challenger-导航(6)
| 
