返回首页

庞巴迪挑战者605公务机机组操作手册 CL605-CHAPTER 17 -导航系统 NAVIGATION SYSTEMS(21)

时间:2011-10-31 11:53来源:蓝天飞行翻译 作者:公务机
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
  

.  
DME-H – holds the last DME frequency when pushed.

 

Cursor Control Panel . ATC Control Figure 17.10.41

MFD Radio Tuning Window
The VHF Nav radio block is located on the left side of the tuning window, next to the communications block. The active frequency is shown in green, while the recall frequency is shown in white.
The tuning box is positioned over the recall frequency by rotating the RADIO ADV selector on the CCP. Direct tuning changes can only be made when the PUSH SELECT button is pressed.
When the tune box is made active, the box is split in two. Coarse tuning is carried out by the RADIO ADV selector, while fine tuning is carried out by the DATA selector. Pressing the transfer button on the CCP switches the active and recall frequencies.
Selecting the 1/2 button on the CCP causes the VHF Nav radio block to show tuning information from the opposite VHF navigation radio. The NAV legend at the top of the data block is shown in yellow, indicating that cross-side data is being displayed.


 NAVIGATION SYSTEMS Description  Vol. 2  17.10.41 
Oct 05/06 

If the DME hold (DME-H) button on the CCP is pushed, the hold frequency is shown below the recall frequency. It is shown in green to indicate that the frequency remains active for DME operations.

MFD Radio Tuning Block Figure 17.10.42

MFD Radio Tuning Control Page Navigation
The VHF Nav radio’s CONTROL menu is accessed by positioning the tune box over the VHF Nav radio, then pressing the RADIO button on the cursor control panel. The RADIO ADV/DATA selector and center PUSH SELECT button are used to move and make selections in the submenu.
AUTO is displayed in cyan below the recall frequency, if navigation autotune has been enabled from the FMS CDU.
The NAV 1 (2) CONTROL submenu provides control of the following:
.
Active/Recall frequency;

.
DME hold frequency;

.
Marker beacon sensitivity; and

.
Test.


The cyan transfer symbol is shown on the Main and Control menu when valid frequencies are available. The FREQ button on the CCP is used to swap the frequencies.


 NAVIGATION SYSTEMS Description  Vol. 2  17.10.42 
Oct 05/06 


VHF Nav Sub-Menu Control
Figure 17.10.43

VHF Navigation Indications

Description
The following VHF navigation information may be presented on the flight displays:
.
Active and preset source information;

.
Course selector;

.
To/From indicator;

.
Course or localizer deviation;

.
Glideslope deviation;

.
Marker beacon; and

.
Bearing indications.

 

Active and Preset Source Indications
Active and preset NAV source data is presented on the left side of the PFD’s Nav display, in all formats. An upper block shows active NAV source information, while a lower block displays preset NAV source data.
 
中国公务机网 www.gongwuji.com
公务机翻译 www.aviation.cn
本文链接地址:庞巴迪挑战者605公务机机组操作手册 CL605-CHAPTER 17 -导航系统 NAVIGATION SYSTEMS(21)
 

------分隔线----------------------------