返回首页

庞巴迪环球5000公务机机组操作手册 Bombardier Global-导航(24)

时间:2011-11-11 09:40来源:蓝天飞行翻译 作者:公务机
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
  
If a video input is being displayed, selection of other function keys (PERF, NAV, FPL, PROG, DIR) will return the display to normal FMS operation.
NOTE
If an annunciator and/or scratchpad message is displayed while viewing a video input, the display will return to the page shown before the VIDEO key was pressed.
.  GRAPHIC Key (CDU.820 only) . Depending on installation, pressing the GRAPHIC function key results in the following: . The scratchpad message GRAPHIC NOT AVAILABLE will be displayed if there is no external video input to the or if access is externally selectable.
.  If a graphic input is available and access is internal to the CDU, the GRAPHIC INDEX page will be displayed.
If a graphic input is being displayed, selection of other function keys (PERF, NAV, FPL, PROG, DIR) will return the display to normal FMS operation.
NOTE
If an annunciator and/or scratchpad message is displayed while viewing a video input, the display will return to the page shown before the GRAPHIC key was pressed.
.  
ATC (Air Traffic Control) Key (CDU.820 only) . Pressing the ATC function key will display the scratchpad message ATC NOT AVAILABLE.

.  
BACK Key (CDU.820 only) . Pressing the BACK function key will display the scratchpad message BACK COMPLETE unless video or graphic input is available. If a video or graphic input is accessed thought the VIDEO INDEX or GRAPHIC INDEX page, pressing the BACK function key will return the display to the VIDEO INDEX or GRAPHIC INDEX page. Pressing the BACK function key again will return the display to the page shown before the VIDEO or GRAPHIC key was pressed. Pressing the BACK function key a third time will display BACK COMPLETE in the scratchpad.

.  
FN (Function) Key (CDU.820 only) . Pressing the FN function key will display the scratchpad message FN NOT AVAILABLE.


Pressing and holding the FN function key for 5 seconds will display the SYSTEM SETUP page.
Rev 2A, Apr 11, 2005 Flight Crew Operating Manual  Volume 2

Scratchpad
The scratchpad is a working area where the pilot can enter data and/or verify data before line selecting the data into its proper position. Alphanumeric entries are made into the scratchpad using the keyboard. As each key is pushed, the character is displayed in the scratchpad. Information in the scratchpad does not affect FMS until it is moved to another line on the display. Data is retained in the scratchpad throughout all mode and page changes.

Alphanumeric Keys
The alphanumeric keys are used to make entries into the scratchpad. The letters of the alphabet, the numbers 0 to 9, a decimal, a dash and a slash are each represented with a CDU key.
Clear (CLR) Key
The CLR key has the following functions:
.  
When a message is displayed in the scratchpad, pushing the CLR key deletes the message.

.  
Temporary waypoints are identified with an asterisk (*) or pound sign (#) as the first character. When any entry beginning an * or a # is in the scratchpad, pushing the CLR key deletes the entire entry.
 
中国公务机网 www.gongwuji.com
公务机翻译 www.aviation.cn
本文链接地址:庞巴迪环球5000公务机机组操作手册 Bombardier Global-导航(24)
 

------分隔线----------------------------