曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
Fault detection is achieved through the Built-In Tests (BIT). When a failure is detected, the data at fault is removed from the ISI and the applicable warning flag (ILS and SSEC) or cross (attitude, altitude, LOC and G/S) is displayed.
BARO STANDARD SELECT FUNCTION
BAROMETRIC PRESSURE (hPa)
ALT SCALE
GLIDESLOPE
POINTER
BARO ADJUST KNOB
CAGE BUTTON
RGF1110_516
Rev 5, Jul 21, 2005 Flight Crew Operating Manual Volume 2
FLIGHT INSTRUMENTS
Two digital clocks synchronized to GPS time and date from GNSSU No. 1 are installed in the cockpit. The clocks provide time and date information for the avionics equipment. Each clock provides GPS or internal time and date, local time, chronometer and elapsed time functions. The clock automatically enters GPS mode when the clock receives a valid GPS signal and automatically enters Internal mode if the GPS signal becomes invalid.
When power is initially applied to the clock and GPS is invalid, the clock enters SET mode and all functions can be set in sequence. The clock will enter normal operation by pressing the MODE button for 2 seconds.
After the clock has been set via GPS or manually, changing the time and date is accomplished by entering each mode individually and pressing the MODE button for 2 seconds. When setting is finished, press the MODE button for 2 seconds to enter normal operation.
NOTE
If GPS is valid, only local time can be changed.
Time/Date Display ET SEL Pushbutton
Displays the following: Enters ET mode and displays
GPS (UTC), Internal or Local time current elapsed time. Used to
in hours, minutes and seconds. decrease data during time setting.
ET RST Pushbutton
Resets the elapsed timer (only active with WOW). Used to increase data during time setting.
ET/CHR Display
Displays elapsed time or chronometer time. ET in hours and minutes and CHR in minutes and seconds.
Used in conjunction with the CHR Pushbutton
ET SEL/RST pushbuttons to Controls the start, stop and reset
set time and date.
function of the chronometer display.
GF1110_103
Volume 2 Flight Crew Operating Manual Rev 5, Jul 21, 2005
TIME SETTING
Set at Power.up
At the first application of power, the clock will be in GMT minutes adjustment if GPS is invalid and the clock is not trans,itting on the ARINC bus. If the GPS data is valid, the clock is automatically updated and switched in GPS mode.
In the SET function, the GMT minute’s digits are flashing. The flashing rate is 1e flash per second. The setting is obtained by pressing the ET SEL pushbutton to decrease the data and pressing the ET RST button to increase the data. The counter increments, 1 digit for each push of the button. The INT flag is lit.
.
By depressing the MODE button, the GMT hour’s digit is flashing, and you can adjust the display in the same way. The INT flag is lit
中国公务机网 www.gongwuji.com
公务机翻译 www.aviation.cn
本文链接地址：庞巴迪环球5000公务机机组操作手册 Bombardier Global-飞行仪表(18)
|
