返回首页

庞巴迪环球5000公务机机组操作手册 Bombardier Global-飞行仪表(33)

时间:2011-11-10 10:29来源:蓝天飞行翻译 作者:公务机
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
  
GF1110_084a
Volume 2 Flight Crew Operating Manual Rev 7, Dec 01, 2005
Course Selected/Desired Track Pointer
The selected course/desired track pointer is displayed in the HSI compass. Due to the limited display of the HSI compass, it is possible that only half the pointer is visible.
Selected Course Readout
Conformal Course Selected Bug
Course Selected/ Desired Desired Track Pointer
Track Readout
TO/FROM Indicator
The conventionnal TO/FROM Indication is displayed when VOR/LOC is selected as the primary navigation source.
When the course deviation indicator (CDI) is between ±88° in reference to the VOR course, the TO/FROM symbol indicates TO. When the CDI exceeds ±92° from the VOR course, the TO/FROM symbol indicates FROM. The indicator is removed when the course deviation is between 89° and
91°.
A square replaces the conventional TO/FROM indicator when the FMS or the LOC is selected as the navigation source.
Navigation Source Indication
The navigation source indication is displayed at the lower left of the display. The primary navigation source information and the pilot sensor selection must be present in order to display the navigation source.
Sensor Source Indication
When an alternate data source is selected, an annunciation is displayed to indicate the source selected. The indication is displayed continuously when the pilot and the copilot use the same source.
GF1110_085a
Rev 7, Dec 01, 2005 Flight Crew Operating Manual Volume 2
FLIGHT INSTRUMENTS
 
True Heading Annunciation
The True heading annunciation is located at the left of the navigation source indication, when the FMS True heading as been selected.
Sensor Source Indication
NAV Source
Annunciation

True Heading
Annunciation

GF1110_086
TO/FROM Indicator
Bearing Pointer
Two bearing pointers can be displayed on the HSI compass. Due to the limited visual range of the
HSI compass, at least one part of the pointer will remain in view.
The bearing pointers displayed on the HUD are consistent with the selection on the pilot’s PFD.
Two of the following bearings can be displayed simultaneously:

.
VOR 1 or, ADF 1, or Pilot FMS and

.
VOR 2 or, ADF 2, or co-pilot FMS. Bearings are referenced to magnetic north unless true north is selected and indicated on the HUD.


Vertical deviation Scale
The vertical deviation scale is located to the left of the altitude tape. The vertical deviation scale and the altitude tape move together to the right edge of the display to accommodate the FPV when necessary.
Glideslope Deviation
The pointer is displayed to the right of the vertical deviation scale. A limited pointer deviation is shown with half the pointer in view at the appropriate position corresponding to ±2.5 dots.
 
中国公务机网 www.gongwuji.com
公务机翻译 www.aviation.cn
本文链接地址:庞巴迪环球5000公务机机组操作手册 Bombardier Global-飞行仪表(33)
 

------分隔线----------------------------